Yeah so I got this little ball drill bit more than a week ago. Its supposed to be great at drilling holes without clogging. Previously, I was hand drilling with those brittle tungsten HSS bits (which do snap when you least expect it, or expect it) on a Revell Kylo Ren Shuttle. It took me […]
Category Archives: A Piscean Works Blog
20261027 Spinner: Main Board Rev 12
Just after I tested the Spinner Board a few years ago, I knew I had to do another revision, namely because of all the messy wiring coming out from the unreliable connectors. This revision (#12) in a way, solves all that and I am going back to using screw terminals. The 5 rear thruster LEDs […]
20261017 3D Eagle
While I was searching for a 3D Figure of Ryan Gosling as Agent K in Blade Runner 2049 (in anticipation of the arrival of Bellfine’s Agent K Spinner), I came across this nice looking (accurate?) Space 1999 Eagle from the author, mriconoclast from Cults3D. Do look at his collection of other 3D models, which includes […]
20261015 Messing with 3D Builder
I have downloaded 3D Builder some time ago and not having much luck with it the first time round, I did not pursue it further. But just a few days ago, on a whim, I decided to try again, with two objectives: With that in mind, I decided to test with a 3D figure of […]
20261014 JLCPCB’s Online DFM Check
Remember me briefly showing JLCONE’s DFM (Design for Manufacturing) feature some time back? I loved it. This is a feature (like the auto-routers) which I suddenly realised, I could not live without. And because of that, I realised, the (aging) EaglePCB software is quite limited. Apart from the auto-router, it can only help me with […]
