20261115 dinoi’s MkVII ALPHA, BETA, GAMMA, DELTA LEDs

20261115 dinoi’s MkVII ALPHA, BETA, GAMMA, DELTA LEDs

Recently, I found some very good LED replacement for the ALPHA, BETA, GAMMA & DELTA indicators. It is still costly and so, I could not buy them as much as I wanted. I have seen these kind of LEDs decades ago but was not aware of its significance since I have never held nor seen an actual MkVII Prop. So, by the time I realised what these LEDs were, it was too late to get them. Their legs are either corroded or, the asking price was quite ridiculous.

The alternative was to use at least 4 SMD leds to replace that a LED but I would not be satisfied. Because by using this LED, I would have to ensure the other LEDs could also matched it’s height which can be complicated.

20261115 dinoi’s MkVII ALPHA, BETA, GAMMA, DELTA LEDs
Yes! The dimensions of dinoi’s 3D file are good for these LEDs.
So, just for fun, I fired up my pre-Autodesk SketchUp and took a look at the file…
The user interface fascia of a MkVII Tricorder has a very distinctive downward slope. This became a problem to me when I was using SketchUp. So, yeah, I extruded some holes and to get a more accurate measurement. Looking back at my first attempt using a plastic digital vernier, so were quite close except for the distance between the Left indicator and the far right 3 LEDs.
Posted in 3D FIles, 3D Models, 3D Printing, A Piscean Works Blog, Computers, Design, EaglePCB7.77, Electronics, JLCPCB, Lighting, Printed Circuit Board, Resin, Sci-Fi, TR-580, Tricorder.

Leave a Reply