Thanks to the gusts of wind, which got me to putting back this morning’s newspaper together again, I noticed that TheStar have covered Malcom 2026’s event which happened over the Weekend at the Setia SPICE Convention Centre in Penang.
Category Archives: Design
20260615 Malcom 2026: The Aftermath
Let me take a deep breath… a lot had happened. This is the 11th Year for Malcom which is the brainchild of WH Ming of World Hobby Miniatures of Penang. There are a lot of stories on how he formed it but this is not the post. What this post does is to highlight the […]
20260518 1/6th Proton Pack: Revision v005B has arrived
Today is exactly one month since my last foray into this Project. The 0.8mm circuit boards from JLCPCB has long arrived. And just today, so were the special red 2835 (not 3528) SMD LEDs with a dome lens. Which LEDs? Pulling the Brakes… By now, I can say that the Project has gone to the […]
20260425 U.S. Army Nurse Corps from B&L Models
Coming soon from B&L Models would be these four new Models in 1/35th Scale. These figures do look unique and as far as I know, there were no such subject in that scale from any Scale Model Manufacturers until now. And they open up to a lot of diorama possibilities. I do hope I will […]
20260402 My goto Lipo Chargers
The Transition In the beginning, I always recommended using either three AA or AAA batteries to power my circuits. That combination provides a good 4.5 volts which was as close as I could get to 5 volts. The reasoning was that if anyone uses my circuits during a show and runs out of batteries, they […]
