Just after I tested the Spinner Board a few years ago, I knew I had to do another revision, namely because of all the messy wiring coming out from the unreliable connectors. This revision (#12) in a way, solves all that and I am going back to using screw terminals. The 5 rear thruster LEDs (top) has been re-aligned, this time, I hope, will lock straight to the Spinner’s body without much metal calisthenics.
Part of the reason for the revision/update was the wiring. If you look at the image below, it was OK. But once you connect every strand of wire to their connector terminals, they can end up like spaghetti junction. And we’re talking about 60-odd LEDs (well I think so, at the last count). There are potentially 26 pairs of connections for the underside of the Spinner and so, I can re-arrange those and put the screw terminals upside-down. Nah. This does nothing except to make the board thicker and easier for everyone else to wire their LEDs…
Anyway, there were another few changes after this post because. I. Can…
I have moved the two variable resistors from the component side to the solder side. Initially, I was thinking, maybe the User can cut out a removeable bonnet at the rear so that they can adjust the slider. Nah. Not many would do this and so, it is up to them to set the brightness and seal up the model if they want to.