The second version of the Razor Crest’s engine program is completed. And I am also getting wary when it comes to fitting the PCBs again and again. This is because I always forget to trim the inner parts of the engine pods which causes the board to be pushed to one side. And when you […]
Category Archives: Microchip PIC
20230301 Testing the Razor Crest Engines
With nothing much on my plate today, I decided to have another look at the Engines while the revised PCB are on its way. This is because the current board had a missing link to the power rail. Plus, since I have connected the 5mm LED to WW1, the sixth solder pad is free which […]
20230301 The Razor Crest Engine Flicker
OK, so I am not working anymore. So, after sulking the whole morning, it was time to do something while searching for a new job. In the meantime, I decided to take a look into the Razor Crest lighting sequence again. ANOTHER TUNE-UP I have made some changes to make the engine flicker a little […]
20230222 The Razor Crest Engine programming
The programming for the Razor Crest is more or less complete. I am using this to video to explain how it works as best as I can. Later on, I will solder the microcontroller to the actual Main Board. But for the time being, I am going to try one more programming feature. When the […]
20230221 The DIY Programmer Adaptor Video
I created this in 2022 and have been planning to make a video.Normally, I would start off by creating the prototype circuit on the prototype board and at the same time, start creating the program. Sometimes, the problem starts when I do not have the correct components for the prototype board and I would have […]
