THE FINAL REVISION After taking a closer look at the 3D printed TR-595E’s body, I believe I can mount this PCB flat-faced. In other words, only the LEDs are on the upper side of the PCB and they can fit into the already pre-made windows. All I have to do is to just relocate the […]
Category Archives: Printed Circuit Board
20220710 The Height of the Relay
With the 3D part in my hand, one of my questions has been answered. The height of the relay is just a smidgen shorter than the uppermost ledge which is about roughly 5mm. These ledges are responsible for the Lower Interface panel not dropping into the whole cavity. The 5mm height limit is quite a […]
A working Tricorder by OhiCosplay
https://lh3.googleusercontent.com/3RVaOF8TbaG0zKpT2DeNCcWyYACKpr8EI35z9yLFezX3nZYwv-79DQDzD_3GvyXpk4yYH_xhjfPvNu9_2eYeC1Beu3NycoqLFO308PIRjiiTfDQGx3CILPVFVjyK69-zDPk44OEpnXg=w2400
20220707 Auto Routing
THE FUN OF AUTO-ROUTING I am starting to appreciate the auto-routing features in the EaglePCB. It gets the job done and looking at the image below, saved me hundreds of hours. I am very thankful of that fact. Auto-routing is so simple. I just prepare the PCB design, make sure my schematics are correct, and […]
