This is going to be the definitive 2nd revision of the Board. Back in about November 2019, after getting the first version of the Board from JLCPCB, the plan was just a matter of fine-tuning it for the next revision. Some components needs to be moved a smidgen for soldering, fitting, etc. It was all […]
Category Archives: Printed Circuit Board
20250825 Spinner: Upper Roof Revolving Lights pt. 2
OK, let’s look at that revolving light which is sitting at the top of the Spinner. Decades ago, I had no clue as to what everyone else was saying except that the roof light needs to be lit and the complain about Fujimi that the part was not molded in clear plastic. It was not […]
20250817 Spinner Front Mandible
Two and a half years. Yeah. I think that was how long I last worked on the Fujimi Blade Runner Spinner. The Main Board was ready, until I realised the fancy screw-less connector terminals have QC problems which led me to redesigning it again. The orange tab would go all floppy which means you cannot […]
20250807 A Relaxing Day
I was putting off soldering of these LiPo Chargers for quite some time as the thought of searching and organising the necessary components was quite daunting. Unfortunately, it is an urgent thing that needs to be done ASAP but I was procrastinating since after soldering the main PCB, I was literally not in the mood. […]
