Here are some of my theories about the 2049 Spinner’s lighting and its sequence. There are quite a lot of theories so I will split them into two Segments; from the Movie and those who worked on it.
From the Movie
The Interior
At that time, this was the only source for me to examine the Spinner’s lighting. There are a lot of images and sources but by the time the Bellfine kit came out (November, 2026) it was mostly links to Spinner toys being sold.
On the Driver’s Dashboard, there are two screens along with a pair of smaller LCD status readouts. The ‘iPad’ Monitor on the right is flexible.
I would like to re-create these screens although they looked very small on the 1/32nd Scale Model kit.
The three small Blue LCD screens on the dashboard. The fourth monitor, is based on the swivel arm which after seeing the model’s instruction kit, will have to be scratch-built for lighting.
I will have to take a look at the model to determine if the Peugeot emblem is molded inside.
Apart from the reflection in the monitor, I think this is the the best shot for the fourth monitor.
In certain scenes, there is a blue glow inside the cockpit, which I think would have come from the Monitors. The detail above looked like a reading light for both Pilot and Passenger but I cannot confirm this.
The rear Red Detail
In the promotional posters when they were showing the Spinner’s rear, there was always that red lighted detail near to the ‘red thrusters’. However, in the Movie, it was hard to prove, maybe I lacked the patience to search for it, frame by frame.
In theory, the pair of red details are somewhere around here, based on the Promotional Posters.
The Side and (almost) Top lighting details. Some of the lights are not there if you compare to other screen/ scenes.
Apart from the rear pair of white LED, these are the clearest detail for all the lights under the Spinner.
Oh, hey, the red LED above K finally lights up!
The lighting detail on the front mandibles of the Spinner. Notice how the curved detail housed 3 pairs of light sources.
Strange that in this scene, the roof’s red lights were not lit while the rear (next to the Drone was). Then again, we could be witnessing K switching everything off as the Spinner descents into the Scrapyard. I thought the pair of white lights are the front of the mandibles were located just after the orange triangle…
But there were no such outlet for it so, that means the white lights were shown partially from the Spinner’s curved lights.
Maybe it is a glitch or, the light was really on but the immediate surface’s paint had absorbed it. Later in the Movie, it did light up.
Starting the Drone
During the attack, K uses the Drone to hit one of Luv’s Spinners. The launch showed quite a lot of lighting details the the rear. The Instruction Manual showed the Drone was assembled from three ‘B’ parts, none of them were clear.
Looking at the red lighting detail, it reminds me of those Flashlights using conical lens to amplify the LED’s light ala Collimator lens first originated from Luxeon, more than 2 decades ago. But it does remind of my small portable flashlight.
In this scene, to me, I felt that as if the lower white LEDs blinked first before of the upper red pair.
From the Prop
This is one of the Websites where I will consolidate all my lighting theories on. The images are courtesy from Robert Stannage via Makezine.
There is a white light behind the Pilot’s seat but it is not in the model
The only way to light up those inner door panels (that is, if you want to display the Spinner with the door opened) is to drill out the openings for the LEDs but you will need to very. very careful since this is a single piece with the other being the clear plastic. The you will have to light the interior courtesy lights, with one behind the seats (but I am not sure with the one abouve the front windshield). But if you close the door, then you would only have to worry about cutting out the triangle for the orange LED.