20261118 dinoi’s MkVII: Recreating the Main Board

20261118 dinoi’s MkVII: Recreating the Main Board

I have designed the Main Board quite some time ago in 2023 and the measurements were done through a digital vernier. I cannot remember but I think it was sometime in 2024 that I tried importing .stl files into the pre-Autodesk (now Trimble) SketchUp software. This was the only 3D software that I was most familiar with and also, it was perfect for my work where Room Planning and Interior Design was crucial despite not knowing anything about the latter.

Starting back to Square One

So, once again, I am designing the Board from scratch. The previous version was kinda OK but they were using smaller SMD LEDs for the APLHA, BETA, GAMMA and DELTA indicators. This would create a very noticeable hotspot, something which I do not like. Alternatively, I can replace that with at least 4 smaller SMD LEDs but again, I would not be able to get a uniform green light effect. So, with the recent discovery of those 5mm x 10mm LED bars, I am hoping to solve this issue. The issue with these LED bars are that the opening for them to slot into must be designed with precision.

20261118 dinoi’s MkVII: Recreating the Main Board
The software took quite some time to calculated stuff before I could get something on the screen. I would be lying to you if I said the screen was ready while I was making a cup of coffee. It was not.
Mr. dinoi’s 3D file for the MkVII Tricorder has a lot of sloping surfaces and curves. SketchUp was designed for the Architect or Interior Designer who needs to build up a 3D model very quickly. And most of the time, it was all straight lines compared to actual 3D models. Anyway, the information I need was the exact position of all the holes for the LEDs. One way to do this (fast) is to measure the sloping distance between (my) drawn lines in the model or, a piece of flat surface.
There is a small cavity 4mm(h) x 5mm (d) x 16mm(l) in there, which I plan to use either a 3x11mm or 3x14mm rectangular reed switch. A typical glass (and cheaper) reed switch with green glass that I have is more than 14mm long. It’s bending their legs too close to the glass will actually break the glass itself.
On the left is a 2023 design which uses SMD LEDs as I wanted the PCB to stay as close to the underside surface of the Tricorder as possible for the touch capacitance switch to work without using any springs. However, by placing the Sound playback module there, this is not ideal. Not only that, some traces are interfering with the touch pads so I am thinking of using idividual ICs instead of consolidating all touch pads into one IC.
Posted in 3D FIles, 3D Models, A Piscean Works Blog, Electronics, Flowcode, JLCPCB, Lighting, Microchip PIC, Microcontroller, Resin, Sci-Fi, Star Trek, Techniques, TR-580, Tricorder.

Leave a Reply