Category Archives: Design
20220729 The size of the Front Facsia
I think there is an issue with the size of the main body’s decal. Or, that the main body has been revised. Or, I am not right in the head.Just to be sure, I have measured the decal again and again, even resorting to using the miniature peeper yardstick. I have had this issue when […]
20220728 The 020 RGB LED
These very small little 6mm LEDs arrived today and…. did I tell you that they’re very small? Handling them might be a problem if the pair of tweezers suddenly slips. The reason I chose them is because I wanted the lights to fill over a long rectangle. Plus, the lights needs to change colours too. […]
20220726 Testing the Decals
DECALS ON THE LOWER INTERFACE AKA FLAP The Project is slowly winding down for the moment, because, you know, Life. It is also time for me to check out Mr. Duchette’s decals which has been lying about for weeks. This is also a good time for me to test my attempts with the InkScape v1.1 […]
20220726 The Clock Source
To be honest, this feature is not necessary but I put it in because I can. The four LEDs in the Top Panel PCB can run on its own or, sync with the Front Array PCB. You need a soldering iron to make the change, which is to solder a link on the jumpers. You […]
