These very small little 6mm LEDs arrived today and…. did I tell you that they’re very small? Handling them might be a problem if the pair of tweezers suddenly slips. The reason I chose them is because I wanted the lights to fill over a long rectangle. Plus, the lights needs to change colours too. […]
Category Archives: Design
20220726 Testing the Decals
DECALS ON THE LOWER INTERFACE AKA FLAP The Project is slowly winding down for the moment, because, you know, Life. It is also time for me to check out Mr. Duchette’s decals which has been lying about for weeks. This is also a good time for me to test my attempts with the InkScape v1.1 […]
20220726 The Clock Source
To be honest, this feature is not necessary but I put it in because I can. The four LEDs in the Top Panel PCB can run on its own or, sync with the Front Array PCB. You need a soldering iron to make the change, which is to solder a link on the jumpers. You […]
20220720 The Fail
Remember the PCB design which I totally forgot and sent it off to JCLPCB? Well, it has arrived today and I was so happy. My hands were trembling again but I know it is not with happiness but with suspense. To be honest, that design is actually a ‘still in progress’ work and there are […]
20220719 The IKEA Hovsta Photo Frame
THE MCO OR WHY WE SHOP ONLINE NOWADAYS The Malaysian MCO (Movement Control Order) affected a lot of Lives during the Pandemic. Shops either had to close or, conform to certain restrictions. Most of us were on standby and so, I wanted to get some Projects done, hoping to raise some cash. The idea is […]
