I was pleasantly surprised this morning when images of the Blade Runner model kits showed up on my SocMed feed. They are from the company Bellfine with the molds developed by Woodbell Co., Ltd.. The following images are courtesy of HOBBY SHOP Dejitamin. I have already developed the Lighting System for the Blaster (but it […]
Category Archives: Lighting
20251008 Gecko Models 35GM0118: Painting and Lighting
So, it is time to paint the whole assembly as much as I can. And I do not like painting unless I feel like it, which is never that often. So, you can tell how good I am with this lest minute effort as I tend to slap on any paint within arm’s reach. The […]
20250923 Spinner: Top Revolving Light New PCB Design pt.2
The re-design of the PCB arrived from JLCPCB in just 11 days. In summary, this circuit board is to connect 5x 0805 type SMD LEDs to simulate the revolving siren light at the top of the Spinner. Originally, it was a 2 PCB concept where the LEDs were sandwiched between the two boards. However, during […]
20250922 Razor Crest The Continuation
From a Land Far, Far, Away… Oh, wow. My last update on this Project was in 20240217. And that’s more than one and a half years ago! And it was also the time of uncertainty due to a tribal scuffle resulting from a deteriorating papa. It was also the time where I had to slow […]
20250921 Gecko Models 35GM0118: Lighting Effect II
Today, I am going to discuss a little about the lighting effects of the side-viewing SMD LED. In the earlier test, the LED was taped on the surface of the ceiling. This was the ideal setup because the Conex Box does not have any trunking or solutions to conceal electrical wiring. What’s more, in this […]
