Are you high? A typical height of a 5mm LED is 8.7mm (1mm collar and 7.7mm resin lens). Add that to the 3mm spacer, we’re looking at a 11.7mm height. But as shown above where the 0mm height LED position looked more accurate, lets have a brief calculation about the 3mm LED. Its typical height […]
Category Archives: Modifications
20251223 Writing a Manual. This is the Way
The one thing I hate about Projects is the Manual writing part. In the beginning, it was fun but now, it felt more like a chore. Based on the experience on the previous Product, I was quite concerned that many who has bought it did not RTFM, as in Read The Fragging Manual. I am […]
20251218 More Images about the Die-Cast Spinner
I am not sure if I did highlight the die-cast Spinner from Master Replicas some time ago as I could not find the post. Anyway, while I was bored, I entered the search for the Spinner on a Chinese B2C platform and it came up with these three images. I am very sure it has […]
20251215 MS-06Z Bishop by Hary Nugraha
This is a very nice take on converting a 1/144 DOM into using the Zaku Psycommu System. And this version by Hary Nugraha really stands out.
20251102 Spinner: There’s Something Wrong with the Circuit
So, with the revolving LED done, and now I only have to test-fit the front mandibles by searching for the Spinner’s parts hidden in the stash somewhere, I am ready to finalise the Main Board. This is going to be so good that I can foresee the Project move on to Production stage by 2026! […]
