Yesterday, I got the opportunity to collect the long-awaited 3D prints. And I am quite impressed with the result. We did discuss more on going further on this Project but as it started to rain and my Wife wants me back asap, we have to cut everything short. In hindsight, this would be much faster […]
Category Archives: EaglePCB7.77
20240505 Lighting for the AndersFP Blaster pt.01
Just yesterday, I saw a friend of mine, Dean Eyre on Facebook asking for some assistance to light up one of his models. It was a very simple request where 5 red LEDs needs to “glow up” once power is applied to it. At that time, the only clue was his posted image below: ORIGIN […]
202040408 1/6th Proton Pack: The Guesstimation Process
Fitting a circuit board into a scale model is quite challenging and it usually ends up being a bespoke design. The challenge is to maximise the space within and making sure all the components fit in there. So far, in most scale models, I can skip this process because the available space was more than […]
20240217 Razor Crest Main Board Rev.05
After more than about 10 days, the newly re-deisigned (and I hope, the final version) of the Razor Crest’s main board has arrived. The circuit is the same except that it has been re-wired slightly to fit into the new screw terminals. To make or rather, allow for last-minute re-soldering, I have moved the components. […]
Protected: 20231018 The Revised Sensor Board
There is no excerpt because this is a protected post.
