In the beginning There are some developments in this Hobby which sometimes pushes me beyond the edge and I am not talking about comfort zone. For over more than a decade, I have witness my own development in terms of PCB design and the final products. From basic marker etching to using photolithograhy using software, […]
Category Archives: JLCPCB
20250826 Spinner: Changing the Design
This is going to be the definitive 2nd revision of the Board. Back in about November 2019, after getting the first version of the Board from JLCPCB, the plan was just a matter of fine-tuning it for the next revision. Some components needs to be moved a smidgen for soldering, fitting, etc. It was all […]
20250825 Spinner: Upper Roof Revolving Lights pt. 2
OK, let’s look at that revolving light which is sitting at the top of the Spinner. Decades ago, I had no clue as to what everyone else was saying except that the roof light needs to be lit and the complain about Fujimi that the part was not molded in clear plastic. It was not […]
20250817 Spinner Front Mandible
Two and a half years. Yeah. I think that was how long I last worked on the Fujimi Blade Runner Spinner. The Main Board was ready, until I realised the fancy screw-less connector terminals have QC problems which led me to redesigning it again. The orange tab would go all floppy which means you cannot […]
