OK, let’s look at that revolving light which is sitting at the top of the Spinner. Decades ago, I had no clue as to what everyone else was saying except that the roof light needs to be lit and the complain about Fujimi that the part was not molded in clear plastic. It was not […]
Category Archives: JLCPCB
20250817 Spinner Front Mandible
Two and a half years. Yeah. I think that was how long I last worked on the Fujimi Blade Runner Spinner. The Main Board was ready, until I realised the fancy screw-less connector terminals have QC problems which led me to redesigning it again. The orange tab would go all floppy which means you cannot […]
20250807 A Relaxing Day
I was putting off soldering of these LiPo Chargers for quite some time as the thought of searching and organising the necessary components was quite daunting. Unfortunately, it is an urgent thing that needs to be done ASAP but I was procrastinating since after soldering the main PCB, I was literally not in the mood. […]
20250705 The Phosphor LED
One of the things that irks me during the design of the Playmates Toys MkVIII Tricorder or the actual replica, is that I cannot get uniform lighting on the four ALPHA, BETA, GAMMA & DELTA indicators. I can use SMD LEDs, push it deeper by a few milimeters and stick a diffuser in the front. […]
