This is a very good guide showing more or less how an Electronics Project comes to life.
Category Archives: JLCPCB
20240909 Lighting for the AndersFP Blaster Pt.17 – Heat-shrink Tests for the LiPo Charger Adaptor
The transparent heat-shrink tubing has arrived and this means, I can complete the testing of this Charger. The heat-shrink not only minimises shorting but also, updates the User on the status of the charge; red for charging and green for complete. Where to get what: AndersFP (Anders Fogde Pedersen) PKD-2019 Blaster Download File Duplex Designs […]
20240906 Lighting for the AndersFP Blaster Pt.16 – The PKD & The Ghost Boards
OK, these boards are more or less done with the prototype design stage. In the last revision, everything worked out nicely. But this time, I will go over the designs again because I was quite busy and literally forgot there I left off. Just some more last minute revisions and it’s off to JLCPCB! There […]
20240905 Oops
In what seemed like an oscillating crystal soldered to a QFP chip of sorts above has some very interesting theories on Facebook. But do note that there is no facility available to put the crystal on the PCB, not even a silkscreen. Some of them were: But the photo, hilarious to most, felt painful to […]
20240829 Lighting for the AndersFP Blaster Pt.15 – The New LiPo Charger
Wow. What a day yesterday was. I’ve received the package from JLCPCB and this time, the Postman knew where to find me since I was busy at the rear end of the Workshop. So, after a brief glimpse of the PCBs, I chucked it into the bag. Wake up, time to charge Then this morning, […]
