Um, yeah, I just created version 4.0…It’s not what I’d normally do but with the 3D print in my hand, I did more and more measurements and modified the board further. This time, I have decided not to implement any sensors if the trigger was pulled halfway. It is fun but figuring out the optical […]
Category Archives: Flowcode
20240505 Lighting for the AndersFP Blaster pt.01
Just yesterday, I saw a friend of mine, Dean Eyre on Facebook asking for some assistance to light up one of his models. It was a very simple request where 5 red LEDs needs to “glow up” once power is applied to it. At that time, the only clue was his posted image below: ORIGIN […]
20240217 Razor Crest Main Board Rev.05
After more than about 10 days, the newly re-deisigned (and I hope, the final version) of the Razor Crest’s main board has arrived. The circuit is the same except that it has been re-wired slightly to fit into the new screw terminals. To make or rather, allow for last-minute re-soldering, I have moved the components. […]
Protected: 20230923 My Tricorders
There is no excerpt because this is a protected post.
20230306 Razor Crest Lighting: The Engines
OK, this is a filler post if you want to call that. To me, the engine lighting for the Razor Crest is the most significant feature of the craft. It was also the most frustrating. I was looking for off-the-shelf solutions such as the COB (chip on board) LEDs, LED rings and even flash light […]
